Brocade Communications Systems MLX Series Instalační příručka stáhnout pdf (Strana 171)

100

101

Brocade MLX Series and NetIron XMR Hardware Installation Guide 157

53-1003267-02

Installing a NetIron XMR 8000 router

NOTE

For the NEBS-compliant installation, AC power connections must use a surge protection device

(SPD) to protect AC power supplies from damage due to excessive power line surges.

Follow these steps to connect AC power source.

1. Locate the power receptacle on the back panel of the router.

2. Lift the cord retainer and connect an AC power cord to the power supply.

3. Snap the cord retainer over the power plug to hold it in place.

FIGURE 106 Connecting a power cord to the power receptacle

DANGER

If the installation requires a different power cord than the one supplied with the router, make

sure you use a power cord displaying the mark of the safety agency that defines the regulations

for power cords in your country. The mark is your assurance that the power cord can be used

safely with the router.

For information about powering on the system, refer to “Activating the power source” on page 194.

1 Lift handle 3 Power cord

2 Cord retainer 4 Ground point

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 341 342

Komentáře k této Příručce

Žádné komentáře

Brocade Communications Systems MLX Series Instalační příručka Strana 171

Komentáře k této Příručce

Související produkty a manuály pro Sítě Brocade Communications Systems MLX Series