Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 Uživatelský manuál Strana 449

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 494
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 448
Brocade ICX 6650 Layer 3 Routing Configuration Guide 431
53-1002603-01
Basic VRRP-E parameter configuration
NOTE
You also can use the enable command to activate the configuration. This command does the same
thing as the activate command.
Configuring IPv6 VRRP-E
To implement an IPv6 VRRP-E configuration using all the default values, enter the following
commands.
NOTE
You must first configure the ipv6 unicast-routing command at the global configuration level to
enable IPv6 VRRP-E on the router.
Brocade Router2(config)# ipv6 unicast-routing
Brocade Router2(config)# ipv6 router vrrp-extended
Brocade Router2(config-ipv6-VRRP-E-router)# interface ethernet 1/1/5
Brocade Router2(config-if-e10000-1/1/5)# ipv6-address 2001:db8::2/64
Brocade Router2(config-if-e10000-1/1/5)# ipv6 vrrp-extended vrid 1
Brocade Router2(config-if-e10000-1/1/5-vrid-1)# backup priority 50 track-priority
10
Brocade Router2(config-if-e10000-1/1/5-vrid-1)# ipv6-address 2001:db8::99
Brocade Router2(config-if-e10000-1/1/5-vrid-1)# activate
Syntax: [no] ipv6 unicast-routing
Syntax: ipv6 router vrrp-extended
Syntax: [no] ipv6-address ipv6-addr
Syntax: ipv6 vrrp-extended vrid vrid
Syntax: [no] backup [priority value] [track-priority value]
Syntax: [no] activate
The vrid variable specifies the virtual router ID.
The ipv6-addr variable specifies the IPv6 address of the router.
You must identify a VRRP-E router as a Backup before you can activate the virtual router on a
Brocade device. However, after you configure the virtual router, you can use the backup command
to change its priority or track priority.
The priority value option specifies the IPv6 VRRP-E priority for this virtual Backup router. You can
specify a value from 3 through 254. The default is 100.
The track-priority value option changes the track port priority of a Backup router. You can specify a
value from 1 through 254. The default is 2.
NOTE
You also can use the enable command to activate the configuration. This command does the same
thing as the activate command.
Zobrazit stránku 448
1 2 ... 444 445 446 447 448 449 450 451 452 453 454 ... 493 494

Komentáře k této Příručce

Žádné komentáře